7 наконечников 5 секунд Быстрое нагревание устройство горячей фиксации для нанесения страз DIY Инструменты теплофиксации для термоклейкие кристаллы-стразы исправление страз

Подставка для мебели

Choose the correct size applicator tip for the stone size and you will be working with,if unsure,place the tip over the stone.The correct size tip will pick up the stone.The flat tip is uses for flat stone that don't fit into the round tips.Screw in the correct size tip while the applicator is cold! Plug in the applicator wand and switch it on.Leave for about 2 minutes. 1.With a stone facing faceted side up,place the tip over the stone and pick it up.Do not Press hard,the stone may stick to the suface. 2.Watch the glue till it starts looking wet and shiny.Now the stones is ready to be applied to the surface.It will take about 5 seconds and up,depending on the size of the rhinestones or stud. 3.Lightly press the applicator at 90 degrees celsius to the surface.Move the applicator up and away.In case the stone gets stuck in the tip,use a pair of tweezers and push downwards through the slit in the tip to get the stone out. If the stone hasn't bonded correctly,place the tip over the stone for a couple of seconds to melt the glue again. Caution :be careful!The applicator and stones will be hot so do not touch them with your fingers!